Objective To (1) evaluate thoracic limb loads and symmetry, and elbow function and morphology, before and after arthroscopic treatment of unilateral medial coronoid process disease (MCPD), and (2) determine if functional variables correlate with morphologic findings.Study DesignProspective case series.AnimalsDogs (n = 14) with thoracic limb lameness.Methods Dogs were included when unilateral MCPD was confirmed as the cause of lameness. Kinetic analysis of both thoracic limbs, along with kinematic analysis and goniometry of both elbows were carried out before, and 60, 120, and 180 days after partial coronoidectomy by arthroscopy. Radiography and computed tomography of both elbows were performed before and 180 days after arthroscopy.ResultsA nonsignificant (P = .11) increase in the peak vertical loads (PFz), and a significant (P = .022) increase in the vertical impulse (iFz) applied by the affected limb were seen. Symmetry indices improved, with significant differences between sessions (PFz: P = .019; iFz: P = .003). Kinematic variables showed no significant differences, between sessions or when comparing both elbows within sessions. Goniometry revealed no significant differences between sessions, but some significant differences were identified when comparing both elbows within sessions. Osteophytosis and degree of lameness showed no correlation, before (rs = −0.077; P = .79) or after arthroscopy (rs = 0.27; P = .35).Conclusions Kinetic variables improved after arthroscopy, without full restoration of function. Kinematic variables did not change significantly. Osteoarthritis and goniometric measurements in the affected joint worsened. Functional variables did not correlate with morphologic findings. arabic 23 English 137
Jalal Mohamed Abdelhadi(7-2004)

Objective: Metacarpophalangeal joint (MCPJ) radiographic parameters were developed to evaluate MCPJ conformation of equine forelimbs, but the effect of joint rotation during radiography on these parameters has not been reported. The current study examined the effect of the rotation around the vertical axis of MCPJ on 27 MCPJ parameters (12 angles and 15 ratios) and identified the acceptable range of rotation at which minimal amount of changes occurred in these parameters. Design: Descriptive study Animals: MCPJs of seven right forelimbs from seven different horses with no MCPJ abnormalities. Procedures: MCPJs of seven right equine forelimbs were loaded in a load cell to obtain the normal MCPJ angle. They were frozen at −20C° and then scanned using a CT-scan machine. The collected slices were reconstructed to obtain a 3D model of MCPJs, and the dorsopalmar view at zero angle (ZDP) were identified. The view was then rotated around the vertical axis of MCPJ. Snapshots were taken for MCPJ at −10°, −5°, Zero, +5° and +10° angles. All the parameters were measured on the total 35 radiographs and statistically analysed. Differences were estimated per 5° of MCPJ rotation for all the parameters. Results:Generally, the ratio parameters were less affected than the angular parameters during MCPJ rotation. Conclusion and clinical relevance: Rotational angles of vertical ±10° from ZDP were considered as an acceptable range for reliable radiographic measurements of MCPJ parameters. Keywords Equine; fetlock; morphometry; radiology; rotation
Abdulrhman Mohamed Salah Alrtib, Aiman Hussein Saleh Oheida, Mohamed Hamrouni S. Abushhiwa, Helen M.S. Davies(12-2021)

Several reports have discussed possible bony morphological causes of fetlock pathology but without relating them to its morphometry. Radiographic measurement is widely used in constructing numerical databases of bone morphometry. Such measurements would not be reliable unless all factors affecting the radiographs were considered. Therefore, this study aimed to establish a specific dorsopalmar view (DP) for fetlock radiographic measurements, and then to develop reliable and repeatable fetlock parameters that represent fetlock conformation on those DP radiographs. Ten cadaveric forelimbs from ten adult horses were cut at the distal third of the radius and mounted in a normal posture for DP radiography. Specific features on fetlock bones were used as landmarks to identify the DP at zero degrees. Other bony features were selected as landmarks for developing fetlock parameters on these radiographs. Twenty-seven parameters were designed in the form of angles (12) and ratios (15). The repeatability and consistency of each parameter was tested. A specific fetlock DP view was determined at zero degrees based on certain landmarks. All angular and ratio parameters showed high reliability and consistency in their measurements. The established parameters provide an opportunity to test the relationship between fetlock morphometrics and performance, or the likelihood of certain pathologies.
Abdulrhman Mohamed Salah Alrtib, Aiman Hussein Saleh Oheida, Mohamed Hamrouni S. Abushhiwa, Helen M S Davies(3-2019)