فى هذه الدراسة تم تحديد خواص دالة هاملتون بإستخدام نمودج المفاعلة البوزونية IBM-2 وإيجاد أفضل البارامترات لدالة هاملتون وحساب قيم مستويات الطاقة وإحتمالية الإنتقال للنظائر Hg200-194، Kr90-84 ومقارنتها بالنتائج التجريبية والمحسوبة بطرق نظرية أخرى. Abstract In this study, we have determined the most appropriate Hamiltonian using the interacting boson model (IBM-2), and obtained the best fitting values of parameters to construct the Hamiltonian. We also have calculated the energy levels and the transition probabilities for Kr84-90and Hg194-200 and have compared the calculated values with experimental data and with the results of other calculations.
نجاة سالم الشفتري (2010)

Abstract In this work, study was performed using Amorphous polymer – based composites consisting of polystyrene (PS) and carbon black (CB) . Five samples have been prepared with different weight percentage which are (0%CB+100%PS) , (5%CB+95%PS) , (15%CB+85%PS) , (25%CB+75%PS) and (35%CB+65%PS) . The electrical properties have been studied for these samples as follows : Electrical conductivity , relative dielectric constant and the dielectric loss tangent were measured at alternating electric field in temperature range between (30C°) and (60C°) and at four different constant frequencies (100HZ, 1KHZ, 10KHZ and 100KHZ ) . It is noted that the highest value of alternating electrical conductivity at (30C°) is for the sample of composition (25%CB+75%PS) which was (1.25x10 S/m ) and the highest value at temperature (60C°) was for same sample with value of (3.2x10 S/m ) , it should be noted that in general the electrical conductivity increases as the temperature increases where this result shows the behaviour of semiconductors. The relative dielectric constant in the pure sample (0%CB+100%PS) and the other samples with low percentage of carbon black increases as the temperature increases however it decreases as frequency increases. And the samples with higher percentage of carbon black which are (25%CB+75%PS) and (35%CB+65%PS) it was noted that the relative dielectric constant decreases as temperature increases. The lowest value was (1.26) at temperature (30C°) and frequency (10KHZ) for the sample with composition of (15%CB+85%PS), while the highest value at same temperature is (410.2) at (100HZ) for the sample with composition of (25%CB+75%PS), for the relative dielectric constant the highest result it was for the sample (5%CB+95%PS) at (607) at (100HZ) and (45C°). The dielectric loss tangent increases as the carbon black increases in all samples and it was found that the temperature influence will be at high percentage of the carbon black where the temperature of (55C°) the dielectric loss tangent increased to the highest value (1.2X10 ) for the sample of composition (35%CB+65%PS). at the high level of the carbon black it was found that the dielectric loss tangent decreases as the frequency increases.
عادل محمد التميمي (2013)

يشهد العالم زيادة في طلب المياه الصالحة للاستعمال البشرى لاغراض الاستهلاك المنزلي والاستعمال في أغراض الزراعة والصناعة ولقلة مصادر المياه يتوجب علينا البحث عن بدائل بحيث يمكن تطوير وتنويع المصادر البديلة. في هذا العمل تم تصميم ودراسة جهاز لتبخير المياه وتكثيف البخار في درجات حرارة اقل من درجة الغليان للحصول على مياه مقطرة خالية من الأملاح ويتكون الجهاز من اسطوانتين عموديتين لهما نفس المحور تحيط أحدهما بالأخرى وبينهما فراغ. وتثبت الاسطوانتان من طرفيهما السفلي بقاعدة صنعت لهذا الغرض وتغطى الاسطوانتان من الطرف العلوي بغطاء على شكل قمع بحيث تنساب طبقة رقيقة من مياه التغذية على السطح الخارجي للاسطوانة الداخلية فيتبخر الماء بين الاسطوانتين ويتكاثف البخار على السطح الداخلي للاسطوانة الخارجية ويتم جمع المياه المتكثفة عبر المجاري الخاصة لها. وتعتمد الدراسة على حساب الإنتاجية للمتر المربع وتأثرها ببعض المتغيرات مثل درجة حرارة مياه التغذية (في مدى اقل من درجة حرارة الغليان) ومعدل تدفق مياه التغذية وطول سطح التبخير وسطح التكثيف والبعد بين سطحي التبخير والتكثيف. Abstract The demand of fresh water has increased not only for human been consumption, but also for agriculture, industry and domestic use. Whatever the use of freshwater, huge saving of water and improving of water resource is possible. In our work, water distillation units have been designed and built depending on evaporation and condensation principal under low temperature (less than water boiling temperature). This study showed that we can obtain distilled water by using The unit which consists of two concentric cylinders .The internal cylinder (The evaporator) fitted inside the outer one (The condenser) .The base hold both cylinders and collects the fresh and drain water .The cylinders have covered by a cone, the inlet water injected to the unit from the top of that cone and the thin layer of hot water goes over the outer surface of the internal cylinder to provide the system by steam. Then the steam will condense on the inner surface of the condenser. The fresh water productivity has been measured per square meter area by taking in account the effect of some parameters such as inlet water temperature, water flow rate and the distance between the evaporator and the condenser, also the cylinders dimensions.
صلاح أحمد محمد عبد الحميد (2011)